General help and support for your Lindeman through 2010 John Deere crawler
-
JD430C
- 1010 crawler
- Posts: 350
- Joined: Tue May 03, 2005 11:00 pm
- Location: Northfield, Vermont
-
Contact:
Post
by JD430C » Fri May 12, 2006 8:29 pm
i have a friend who has a 420 with a bad front idler. i have a NOS 1010 idler. will the brackets off the 420 idler bolt onto the 1010 idler? thanks
andrew
jds- 450B, 450C, 550, 4020, 3140 MFWD, 5200 MFWD
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Fri May 12, 2006 10:09 pm
No, 1010 uses quite a bit bigger axle than a 420, and also uses bigger seals and thrust plates.
Lavoy
-
JD430C
- 1010 crawler
- Posts: 350
- Joined: Tue May 03, 2005 11:00 pm
- Location: Northfield, Vermont
-
Contact:
Post
by JD430C » Sat May 13, 2006 9:59 am
thanks lavoy. they looked close, but i didnt want to take them apart till i found out if they would or not. thanks
andrew
jds- 450B, 450C, 550, 4020, 3140 MFWD, 5200 MFWD
Who is online
Users browsing this forum: No registered users and 214 guests
