Now I need to get the roller out and pack the gravel back down but there isn't a hitch on the back of the tractor.
So I decided to make up one of those hitches that mount on the 3-point.
The crossbar is made out of 2 inch angle iron with 5/8 diameter pins welded on each end.
A 1/4 x 2 inch flat bar is welded on top for the hitch ball to mount on.
The upright support bar is made out of a piece of 1-3/4 inch square tube.
Here's the finished hitch mounted on the 3-point.
The back side of the angle iron cross bar has a piece of flat steel welded to it to form a triangular shape for strength.
There is a half round notch machined out of the bottom of the upright support to allow any water to drain out.
The hitch allows good clearance for making sharp turns.
The roller is getting filled and then I can run it over the drive.
