JD 440 IC muffler

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
User avatar
JD440ICD2006
350 crawler
350 crawler
Posts: 1113
Joined: Tue Aug 22, 2006 3:57 pm
Location: South Carolina

JD 440 IC muffler

Post by JD440ICD2006 » Wed Jul 07, 2010 10:04 pm

I replaced the silver round muffler on my 440 IC (gas) with the small oval muffler.
I used 500 degree high temp paint and it is blistering off.
Any suggestions on a black paint that will stay on a hot muffler?
1959 JD 440ICD w/64 Power Angle Tilt Blade
1959 JD 440ICD w/63 Manual Angle Blade
1959 JD 440IC w/602 Manual Angle Blade
1959 JD 730D W SE (many options)
1950 JD M S w/M-20 Mower
1952 JD M W
1955 FORD 640 (burns the most fuel)
Top
hemiracing
40C crawler
40C crawler
Posts: 15
Joined: Fri Oct 09, 2009 10:46 am
Location: Maine

Post by hemiracing » Thu Jul 08, 2010 6:14 am

If you go to your local parts store and ask for HEADER paint you will be all set I think it is good for 1500 degrees and if you blister that you have other problems ie to lean.. Paul
Top
User avatar
JD440ICD2006
350 crawler
350 crawler
Posts: 1113
Joined: Tue Aug 22, 2006 3:57 pm
Location: South Carolina

Post by JD440ICD2006 » Thu Jul 08, 2010 7:05 am

Thanks, I will go look for that.
I saw some that was "1200 degrees" but requires a lot of steps of heating and cooling the engine. I did do not have the time to do all of that.
I will go back and recheck the timing and carb settings to make sure it is not too lean. It is running really well even under load.
1959 JD 440ICD w/64 Power Angle Tilt Blade
1959 JD 440ICD w/63 Manual Angle Blade
1959 JD 440IC w/602 Manual Angle Blade
1959 JD 730D W SE (many options)
1950 JD M S w/M-20 Mower
1952 JD M W
1955 FORD 640 (burns the most fuel)
Top
Post Reply

Return to “Early model JD crawler technical support”

Who is online

Users browsing this forum: No registered users and 256 guests