Post support questions about your JD350 and newer crawler here
-
DBCSteve
- 430 crawler
- Posts: 74
- Joined: Mon May 26, 2008 2:58 pm
- Location: Davis, CA
Post
by DBCSteve » Mon Apr 05, 2010 4:42 pm
Anyone had experience in rebuilding the power steering assist system on a 350B? I'd appreciate hearing about your experience.
JD 450C, Serial No. 316559T
formerly owned JD 350B, Serial No. 126738T
Kubota L3400 top-n-tilt
-
MattE
- 430 crawler
- Posts: 82
- Joined: Sun Dec 27, 2009 11:37 am
- Location: Pennsylvania
Post
by MattE » Tue Apr 06, 2010 5:31 am
I've done it. There is nothing to it. all the seals and o-rings are standard. Just make sure to set the distances on the cylinders according to the manual.
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Tue Apr 06, 2010 8:17 am
I would second that, only thing I would add is check the bore on the cylinders, I had to hone mine to get out a small layer of rust.
Lavoy
-
DBCSteve
- 430 crawler
- Posts: 74
- Joined: Mon May 26, 2008 2:58 pm
- Location: Davis, CA
Post
by DBCSteve » Thu Apr 08, 2010 1:19 pm
Thanks. Both good suggestions. I picked up two rebuild kits at Pape Machinery in Sacramento yesterday (along with a replacement muffler -- ouch!).
Steve
JD 450C, Serial No. 316559T
formerly owned JD 350B, Serial No. 126738T
Kubota L3400 top-n-tilt
Who is online
Users browsing this forum: No registered users and 222 guests
