Need a MC bull pinion (Left steering clutch input ?) shaft

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
Denis in MI
40C crawler
40C crawler
Posts: 12
Joined: Tue Jan 13, 2009 1:51 pm
Location: Michigan

Need a MC bull pinion (Left steering clutch input ?) shaft

Post by Denis in MI » Thu Dec 31, 2009 2:32 pm

I had problems with getting my MC to move last winter and over the summer I got it tore down and figured out that the shaft that goes from the ring and pinion to the left steering clutch was sheared off, I need a new one and have not been able to find one any where. I hope someone here can help me.
Thanks,
Denis

User avatar
Lavoy
Site Admin
Site Admin
Posts: 11108
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Thu Dec 31, 2009 3:35 pm

They are readily available.
Lavoy

Denis in MI
40C crawler
40C crawler
Posts: 12
Joined: Tue Jan 13, 2009 1:51 pm
Location: Michigan

Post by Denis in MI » Thu Dec 31, 2009 5:30 pm

The only ones I found were 3 spline not the 6 spline like I need

User avatar
Lavoy
Site Admin
Site Admin
Posts: 11108
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Thu Dec 31, 2009 9:28 pm

3 spline and 6 spline refers to the axle only, not the drive shaft. They are coarse spline or fine spline.
Lavoy

Denis in MI
40C crawler
40C crawler
Posts: 12
Joined: Tue Jan 13, 2009 1:51 pm
Location: Michigan

Post by Denis in MI » Thu Dec 31, 2009 11:07 pm

What I need is the 6 splined shaft that goes from the Center of the tractor out to the Steering clutch, it is about a foot long and the splines are the same as a pto shaft

User avatar
Lavoy
Site Admin
Site Admin
Posts: 11108
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:

Post by Lavoy » Fri Jan 01, 2010 11:21 am

That is the driveshaft, no problem.
Lavoy

Post Reply

Who is online

Users browsing this forum: No registered users and 256 guests