Need a MC bull pinion (Left steering clutch input ?) shaft

Denis in MI · Post by **Denis in MI** » Thu Dec 31, 2009 2:32 pm

I had problems with getting my MC to move last winter and over the summer I got it tore down and figured out that the shaft that goes from the ring and pinion to the left steering clutch was sheared off, I need a new one and have not been able to find one any where. I hope someone here can help me.
Thanks,
Denis

Post by **Lavoy** » Thu Dec 31, 2009 3:35 pm

They are readily available.
Lavoy

Denis in MI · Post by **Denis in MI** » Thu Dec 31, 2009 5:30 pm

The only ones I found were 3 spline not the 6 spline like I need

Post by **Lavoy** » Thu Dec 31, 2009 9:28 pm

3 spline and 6 spline refers to the axle only, not the drive shaft. They are coarse spline or fine spline.
Lavoy

Denis in MI · Post by **Denis in MI** » Thu Dec 31, 2009 11:07 pm

What I need is the 6 splined shaft that goes from the Center of the tractor out to the Steering clutch, it is about a foot long and the splines are the same as a pto shaft

Post by **Lavoy** » Fri Jan 01, 2010 11:21 am

That is the driveshaft, no problem.
Lavoy

JDcrawlers Messageboard

Need a MC bull pinion (Left steering clutch input ?) shaft

Need a MC bull pinion (Left steering clutch input ?) shaft

Who is online