I pulled the engine on my 450c crawler to fix the chatter coming from the clutch and found quite a bit of wear on the input shaft spines.
My question is can I change that shaft through the front cover or do I have to get in there from the top too?
I haven't pulled the clutch housing yet. Just wondering what's ahead.
Thanks.
input shaft 450c
450c input
sorry but you have to go thru the top also to change the input.. the front cover mostly just holds the tranny pump. bearings and seals,,Mark.
350 loader,350c dozer winch and arch,450c winch and arch,450e winch and arch,D37p komatsu lgp dozer,D85 Komatsu dozer,D8k Caterpillar.
Who is online
Users browsing this forum: No registered users and 231 guests