FS: Tension Spring Nuts - JD Part M 3306 T

[Jimmy in NC]

I have just had 9 of these large nuts made at a local machine shop and have 5 extras. I know they will fit a 420 4 roller (what I have) and I assume they cary over in different runs.. maybe Lavoy can help me out with that one.

Anyways these are the 2" hex that centers the idler side of the large springs. I had 2 that were beyond salvage with rot and such so I had some made up. If anyone is interested let me know. I have right at $20.00 each in them between machine shop cost and material cost. I'm not looking to make any money on these, just looking to help others out there that either need new ones for a restoration or would just like to have some.





You can see the one nut in the back as a new washer on it from Deere.

Either send a PM or an E-mail to me at JamesRColeJr@gmail.com if you are intersted.

Jimmy in NC

[Lavoy]

Jimmy,
I just looked at the 420 sitting out here, and it is missing one for sure. Send me two when you get a chance.
Lavoy

[Jimmy in NC]

Lavoy I'll put those in with your seal installer and that preasure plate that I need to send back to you next week. I may have some shims left over too.. if so I'll send them along.