General help and support for your Lindeman through 2010 John Deere crawler
-
ironyetty
- 430 crawler
- Posts: 89
- Joined: Fri Aug 04, 2006 5:40 pm
- Location: Fort Ashby, WV 26719
Post
by ironyetty » Thu May 10, 2007 12:37 pm
Putting my transmission back together on my 440. The manual calls for a end play tolerance of .002-.004 on the shafts, how crutial is this? I set them in and shimed till I had just a tiny amount of play, I don't have a dial indicator but I will get one if this is that crutial? Anyone shed some light on this situation for me?
Thanks in advance,
Cliff
-
Stretch
- 440 crawler
- Posts: 200
- Joined: Mon Feb 19, 2007 6:48 pm
- Location: Albemarle, NC
Post
by Stretch » Fri May 11, 2007 4:31 pm
You need a dial indicator.
Stretch
2010C Dozer, 2010C Loader
If at first you don't succeed, get a bigger hammer.
-
ironyetty
- 430 crawler
- Posts: 89
- Joined: Fri Aug 04, 2006 5:40 pm
- Location: Fort Ashby, WV 26719
Post
by ironyetty » Tue May 22, 2007 5:09 am
I checked the shafts once I got the dial indicator, not bad at the guess I was only about a .001 strong on the tolerance. I knew better when I posted the question just didn't have a dial indicator handy and was wanting to get the thing back together.
Thanks,
Cliff
Who is online
Users browsing this forum: No registered users and 224 guests
