Dozer blade angle

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
User avatar
JD40c
Site Admin
Site Admin
Posts: 221
Joined: Sun Apr 03, 2005 9:14 pm
Location: Athena, OR
Contact:
Contact JD40c

Dozer blade angle

Post by JD40c » Sat Feb 25, 2006 12:31 pm

The pin and pivot points on the #76 blade on my 40C are seriously worn out. I'm welding in new pivot points. What angle of attack should the blade have? Should it be perfectly vertical? Or should the top be tilted back a bit, say an inch or two, compared to the cutting edge so that it cuts better?
1955 John Deere 40C 4-roller
Top
User avatar
Lavoy
Site Admin
Site Admin
Posts: 11108
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:
Contact Lavoy

Post by Lavoy » Sat Feb 25, 2006 9:59 pm

Jeremy,
It will be awful close to vertical.
Lavoy
Top
Post Reply

Return to “Early model JD crawler technical support”

Who is online

Users browsing this forum: No registered users and 232 guests