Clutch adjustment tool question

[MattE]

I have a home-made JD-7 clutch adjustment tool that was given to me. So I'm sure it is made right... if you describe it as a letter "E" laying flat on a table with the legs of the "E" pointing down. what should be the measurement from the table to the center leg of the "E"? A picture would have been so much easier..... Anyway I just want to make certain before I put the final drives back on my 350B. Thanks for any help

[Tigerhaze]

This post is for the earlier crawlers, but Lavoy said the procedure is similar for the 350s so it may may help you:

http://www.jdcrawlers.com/messageboard/ ... adjustment

I think this post has an actual picture as well (my work computer blocks picture links )

http://www.jdcrawlers.com/messageboard/ ... adjustment