2010 outside push converted to 6 way
Re: 2010 outside push converted to 6 way
They are 12" stroke but could have used 10". The tilt is a 6" stroke. I took the time to draw it all up in 3d cad before I built it. I used 12" but didn't like how close to the center they hit if I set them up for full stroke in both directions. The way the are now it hits full on extension but is 2inches from fully collapsed on the collapsed cylinder. I should have a mechanical stop on the blade frame at full tilt but I don't use the angle much and haven't got around to it.
Re: 2010 outside push converted to 6 way
Thanks for the information.
Looks like I need to start planning another project.
Looks like I need to start planning another project.
Too many projects, not enough time
Re: 2010 outside push converted to 6 way
I don't seem to have any pics of your conversion could you e-mail them to me, I want to do the same to mine. Thanks
noah.williams@npmchs.com
noah.williams@npmchs.com
-
- 40C crawler
- Posts: 12
- Joined: Sat Jun 15, 2019 3:43 pm
- Location: Westwen New York State
Re: 2010 outside push converted to 6 way
Hello all. I know this is a 3 tear old post, But am wondering what length stroke and pin to pin dimensions of the cylinders are. I am using this design on my own 2010.
signweld
signweld
Who is online
Users browsing this forum: No registered users and 24 guests