Got the Hydraulics all sealed and working...

[killzoneq2]

I replaced most of the hydraulic lines and replaced the drive belt and got all of the hydraulic system sealed today. Waiting on the radiator now. Once I get that on and that system working, I will know if I need to put any time and money on the right side steering clutch. The left one is fine, and the right one was full of water. I have it all drained, sprayed some PB blaster on the joints and let it soak for a few days. I then Cleaned it all off with Brake Clean. I am hoping that if it is operated for a while it may break free. I actually drove it to its current location today, about 30 feet from where I was working on it. I only let it run for less than 5 min without the radiator at low RPMs. Things seem to be going well for now............. I hope the good fortune continues. Theres nothing like a Chevy and a Deere.