Manual track adjuster wrench

[BKahler]

Lavoy,

I was looking through the parts manual this evening and noticed on page 80-10 of the 440ICD manual a picture of the wrench used for adjusting the tracks. Its item #8 T10391T and it looks like what I would call a crows foot type of wrench. Am I correct? Would you happen to know off the top of your head what size wrench is used on the adjusting nut?

I have set of crows feet that might go up to 2-1/4" or so. I'll have to check tomorrow when I get out to the shop.

Thanks,

Brad

[Lavoy]

Brad,
I just checked on my 440 last week, and the nut on there is 2 1/2" I think, but not sure that it is the correct size.
Lavoy

[JimAnderson]

Brad,
I just took a dial caliper to the track adjuster nuts on my 440 and
came up with 2 1/4". Hope this helps.JimAnderson