General help and support for your Lindeman through 2010 John Deere crawler
-
25spoker
- MC crawler
- Posts: 4
- Joined: Wed Jan 16, 2008 10:18 am
- Location: Wi
Post
by 25spoker » Thu Apr 03, 2008 7:59 am
Lavoy, Do you sell replacement seals for bottom rollers for a 440IC ?
If so, how much? Thanks JW
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Thu Apr 03, 2008 8:15 am
Nothing at this time, I am going try and get them made, but that may or may not pan out. So far, I have had no response, nobody want to mess with the little guy.
Lavoy
-
25spoker
- MC crawler
- Posts: 4
- Joined: Wed Jan 16, 2008 10:18 am
- Location: Wi
Post
by 25spoker » Thu Apr 03, 2008 8:25 am
Lavoy wrote:Nothing at this time, I am going try and get them made, but that may or may not pan out. So far, I have had no response, nobody want to mess with the little guy.
Lavoy
Any suggestions on rebushing a roller. Can get bushings from John Deere. How does it come apart? Just pry off one end being careful not to damage oil seal? JW
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Thu Apr 03, 2008 2:22 pm
They are tough to pry off, but you can rotate the end caps on the axle and they might come off.
Lavoy
Who is online
Users browsing this forum: No registered users and 220 guests
