Allen head bolts, 1010 gas rebuild

[Wilbur]

After 2 1/2 years I am rebuilding my 1010 gas. I found two allen head bolts in my bolt can that I can't remember where they came from. Any Ideas? Also, oil pan has two bolts in either front corners that are larger that the rest of the oil pan bolts. Any ideas on those?
Gee, if I could have gotten bearings sooner I would have remembered. Thanks.

[Jim B]

It would help if you told the diameters and lengths you are dealing with.

The parts catalog shows 2 each 1/2" x 1" socket head cap screws in holes near the front corners of the oil pan.

Two each 5/16" x 3/4" hex head cap screws used in rear holes and 15 each 3/8" X 3/4" cap screws in the other holes.

To help you research parts you have and where they might go, here is a link to the online parts catalog. Many of the hardware sizes are shown.

PC 727 for JD 1010C

[Wilbur]

Thanks Jim, I wasn't exactly sure where they went. An acquaintance who has done a lot of wrenching on farm tractors and equipment showed me where they went.
I disassembled the engine two and half years ago, been waiting on mains and rod bearings, a lot of pondering. Thanks again.