440 steering clutch trouble

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
James Tallent
MC crawler
MC crawler
Posts: 6
Joined: Tue Mar 24, 2009 2:30 pm
Location: central Arkansas

440 steering clutch trouble

Post by James Tallent » Fri Jan 20, 2012 1:39 pm

Steering clutch trouble on my 440ICD. Had both sides apart. Back together with 8/7 plates. Left side works fine. Right side has power to the track, good brake action but the steering clutch will not halt power to the track. I have received the clutch fingers adjusting tool and if I need to disassemble again I will adjust the fingers. I think my problem is in the throwout bearing adjusting collar. Any suggestions.
I have 2 440s a 440ICD one about ready to run and a 440IC for parts
Both are inside arms. Both have 8A winches; one complete except fairlead and one in pieces. I am looking for a fairlead and advice on resurfacing the grouser shoes.
Top
User avatar
Gil
1010 crawler
1010 crawler
Posts: 362
Joined: Fri Dec 14, 2007 3:19 pm
Location: Pennsylvania

Post by Gil » Fri Jan 20, 2012 8:03 pm

So when you pull back on the right lever the engine strains or dies? That is what would happen if the brake was engaged but the clutch was not releasing. You may have some slop in the linkage and adjusting it by the book may look correct but not be releasing the clutch enough or soon enough. Try moving the throwout bearing carrier closer to the pressure plate fingers. Gil
JD440-ICD loader; JD440-IC bulldozer; JD440-ICD backhoe; JD440-I backhoe; JD440-I tractor; + five recumbent JD440-ICs
Top
Post Reply

Return to “Early model JD crawler technical support”

Who is online

Users browsing this forum: No registered users and 265 guests