JDcrawlers Messageboard

Thank you hdokes for the update. Good luck with the flood repairs.
Steve.

Picture server is down again ( 5 months ) hope there is some way to get it back.

Picture server is down again.

After putting the track back on we needed to take it for a test drive.

It been a little quiet here for a few days. Some 2-53 music.

https://www.youtube.com/watch?v=LbmcQPiouH0

https://www.youtube.com/watch?v=9xJqk7Qn_sI

https://www.youtube.com/watch?v=5UXldQqjiE8

https://www.youtube.com/watch?v=1cbJqd_uxks

I used 3 different types of penetrating oil, some cussing, a lot of other ideas and got mine freed up.
It is discribed about 3/4th of the way down on this write up

viewtopic.php?f=1&t=15023

There is a few you tube videos of 440 and 435’s pulling.

https://www.youtube.com/watch?v=sXMPnlkdYKI

This is a nice 440 pulling. There is other videos of this one on you tube

435 making a pull inside.

https://www.youtube.com/watch?v=rkH4KtT_sb0

The 2-53 from a 440 has around 30% more horse power than a gas 40 engine. Its even hard on the upgraded 440 parts.

Is your 40 engine block cracked from freezing. If it is that can sometimes be repaired. “Stitching, Brazing and epoxy have all worked for me.

The Deere shed

The engine clutch on this crawler had become soaked with oil because the bell housing drain hole was plugged. The hole was plugged with a piece of a set screw that had been sheared in half. No idea where the set screw came from I believe if the drain hadn’t plugged the small main seal leak would hav...

New front and rear crankshaft seals, new camshaft and balance shaft seals. New clutch,release and pilot bearings. http://jdcrawlers.lcent.com:8000/johndeere/albums/userpics/10056/IMG_1129.jpeg New friction disk’s for the throttle control. http://jdcrawlers.lcent.com:8000/johndeere/albums/userpics/10...

sweeperman wrote: ↑

Thu Jul 16, 2026 3:07 pm

nice engine hoist

Thanks.
It is the most used pice of equipment I have.

Broken down crawlers have a way of finding friends.

Kolot
I have seen tracks with rebar welded on them. They seemed to work better than if they didn’t have any.
Warpage shouldn’t be a problem.

I got this 440 in June of 2022. It was tired but with some adjustments and a handful of minor repairs it has been a work horse. http://jdcrawlers.lcent.com:8000/johndeere/albums/userpics/10056/IMG_0423.jpeg The clutch had started slipping so out came the engine. http://jdcrawlers.lcent.com:8000/john...